基于数值模拟的汽车后纵梁工艺面优化设计
Optimization Design of Addendum Surface of Automotive Rear Side Rail Based on Numerical Simulation
周 杰1, 倪志鸿1, 李 慧1, 杨 明2
点击:3496次 下载:0次
作者单位:(1. 重庆大学 材料科学与工程学院,重庆400044;2.四川宜宾普什模具有限公司,四川 宜宾 644007)
中文关键字:数值模拟; 后纵梁; 工艺面
英文关键字:numerical simulation; rear side rail; addendum surface
中文摘要:以某车型后纵梁为研究对象,介绍了该后纵梁成形工艺,并对原工艺面方案产生翻边起皱的原因进行了分析。针对原方案的不足,进行工艺面优化设计,并利用有限元数值模拟仿真软件Dynaform对新方案的拉延、修边及翻边过程进行了模拟仿真。模拟结果与实际生产结果对比,验证了新工艺面方案的合理性和数值模拟的准确性。
英文摘要:Taking automotive rear side rail as research object, its main forming process was introduced, and the wrinkle reason in flange process of initial addendum surface project was analyzed. Aiming at the limitations of initial project, the addendum surface was optimized, and the processes of drawing, trimming and flanging were simulated by using finite element analysis software Dynaform. By comparing the simulation results after optimization with the experiment results, the rationality of new addendum surface project and the validity of numerical simulation were validated.