网络编辑平台

编辑出版

《热加工工艺》编辑部

  主办单位:中国船舶集团有限公司第十二研究所;中国造船工程学会

  主管单位:中国船舶集团有限公司

  地址:陕西兴平市44号信箱

  邮编:713102

  电话:029-38316273

  邮箱:rjggy@vip.163.com

在线调查

相关下载

友情链接

您所在位置:首页->Label


0Cr13Ni8Mo2Al 钢在900~1050 ℃时的变形组织演变规律研究
Investigation on Deformation Microstructure Evolution of 0Cr13Ni8Mo2Al Steel at 900~1050 ℃
舒小勇1, 鲁世强1, 刘大博2, 金建军2
点击:3747次 下载:0次
作者单位:(1. 南昌航空大学 材料科学与工程学院, 江西 南昌 330063; 2. 北京航空材料研究院, 北京 100095)
中文关键字:0Cr13Ni8Mo2Al钢;组织演变;动态再结晶
英文关键字:0Cr13Ni8Mo2Al steel; microstructure evolution; dynamic recrystallization
中文摘要:采用Gleeble热模拟试验机,在变形温度900~1050 ℃和应变量0~0.69条件下对原始等轴组织的0Cr13Ni8Mo2Al钢进行等温恒应变速率(10 s-1)压缩试验,研究了0Cr13Ni8Mo2Al钢变形组织的演化规律。结果表明,在本实验变形条件下,0Cr13Ni8Mo2Al钢在变形过程中没有发生完全再结晶,只发生部分再结晶。当应变量小于0.29时,再结晶非常少;当应变量达到0.29后,再结晶明显增多。当变形温度为900~1000 ℃时,平均晶粒尺寸随温度的变化较小;在1000~1050 ℃时,平均晶粒尺寸随温度的变化较大。当应变小于0.29时,平均晶粒尺寸明显地随应变增大而减小;当应变达到0.29时,平均晶粒尺寸缓慢地随应变增大而减小。
英文摘要:Isothermal compression test with constant strain rate(10 s-1) was employed to investigate the microstructure evolution of  0Cr13Ni8Mo2Al  steel  at  the  temperatures of  900 ℃~1050 ℃ and  the  strain  range  of  0~0.69  by  Gleeble simulator. The results show that, under experimental conditions, full recrystallization of 0Cr13Ni8Mo2Al steel does not occur, only partial recrystallization occurs. The amount of recrystallized grains is a little when the strain is below 0.29, but the amount increases obviously after the strain 0.29.  The  average  grain size changes lightly with the temperature at 900 ℃~1000 ℃, while the effect of temperature on grain size is obvious at 1000 ℃~1050 ℃. When the strain is below 0.29, the average grain size decreases obviously with the increase of strain. Nevertheless, after the strain reaches 0.29, the average grain size decreases slowly with the increase of strain.
读者评论

      读者ID: 密码:    点击此处进行授权 点击此处进行授权
我要评论:
国内统一连续出版物号:61-1133/TG |国内发行代码:52-94 |国际标准出版物号:1001-3814 |国际发行代码:SM8143
主管单位:中国船舶集团有限公司  主办单位:中国船舶集团有限公司第十二研究所;中国造船工程学会
开户银行:工商银行陕西省兴平市板桥支行  帐户名:中国船舶集团有限公司第十二研究所  帐号:2604031909022100458
版权所有©2024热加工工艺》编辑部 陕ICP备10008724号
本系统由北京菲斯特诺科技有限公司设计开发